Description:
0-200 RPM 33*20*18cm Power Feed X-Axis 150 Lbs Torque for Bridgeport Type Milling Machine
Specification:
Type: X-axis
Material: Aluminium Alloy
Torque: 150 lbs
Voltage: 110V / 220V
(There is voltage choice fro you to choose, please make sure you choose the right voltage you need.)
Rotate Speed: 0-200 rpm
Size: 33x20x18cm / 12.99"x7.87"x7.09" (appr.)
Plug: EU Plug (we will base on your country to send the corresponding adapter plug)
Features:
* Better surface smoothness.
* Limit switch for sensitive stop.
* No loss of dial or hand crank.
* Noiseless direction changes.
* Small volume and easy installation.
* Variable speeds. Effortless operation.
* X-axis power feed for milling machines.
* 0-200 rpm rotate speed. Longer lifespan.
* Reversible and auto shut-off at end of cut.
* Excellent speed control in the entire range.
* Direction control knob for easy and rapid operation.
* Power table feed won't vibrate or strain in low speed.
* Safety feature to protect transmission gear and electronic components.
Introduction:
Speed Adjust Knob
Speed can be adjust according to operator’s requirement, ranging from 0-9.
Jog Switch
Normally, jog switch should be at “FEED” position. For jog movement, just switch to "0" position. Kept holding the switch until it travels to requires position.
Attention:
* Be sure to follow the procedure for jog operation to avoid any damage caused by wrong movement.
* Make sure the power feed stops before you change the direction.
* The switch should be in the "OFF" position when the machine is not in use or before plugging.
Maintenance:
* Gear cover must be open every 6 month to check whether lubrication for spiral gear is sufficient. Graphite type lubrication is suggested rather than silicon type.
* Carbon brush cap should be open every 6 month to check if the brush has wore out. Brush should be replace immediately if its length is under 5mm (front and back brush should be replaced together).
Package included:
1pc X-Axis Power Feed for Milling Machine
1Set of Necessary Accessories
Notice:
1. Please allow a bit error due to manual measurement. please make sure you do not mind before you bid.
2. The color may have different as the difference display, pls understand.
More Details:
,
,
,
,
,
,
,
,
,