Technical Data:
Input Power:DC24V
Standby Current:<5MA
RF Frequency: 433Mhz
RF working mode:superheterodyne
Receive sensitivity: >97dbm
Transmitting distance:>100m ( open space)
Decoding mode:MCU software decoding
Remote storage:25pcs
Support remote type: Learning code, Fixed code(Rolling code can be design)
Working mode:Momentary, Toggle, Latching Time delay (5s ,10s ,15s )
Wiring type:fixed terminal
Output Terminal :NO , NC , COM
Dmension of PCB:35*30*18mm (L,W,H)
Wiring diagram 1:
+V : 24V + input ;
- V: 24V - input ;
NO: Output , normal open;
COM:Output , common ;
NC: Output , normal close;
Working Mode:
Momentary: Push the remote button , the relay connects, release the remote button , the relay dis-connects.
Toggle: Push once the remote button , the relay connects , push twice the remote button , the relay dis-connects .
Latching: Push the remote button A, the relay connects, push the remote button B, the relay dis-connect.
Tiem delay mode : Push the remote control button , the relay connects , from when release the remote button , after 5s or 10s or 15s , the relay disconnect automatically .
Clearing the code:
1. Push the learning button on the receivers for 8 times , the codes will be cleaned .
2. After clearning the code, all the remote control cannot work any more.
Learning the code :(momentary)
1. Push the learning key on the receiver once time , it comes into momentary setting mode .
2. Wait for a moment , the LED will be off , it comes into learning state .
3. Push the remote button , LED indicator on the receiver board will flash then come off .
4. After 3 seconds, the LED indicator will be on again , learning successfully .
Learning the code : ( Toggle )
1. Push the learning key on the receiver twice time , it comes into toggle setting mode
2. Wait for a moment , the LED will be off , it comes into learning state .
3. Push the remote button,LED indicator on the receiver board will flash then come off.
4. After 3 seconds , the LED indicator will be on again , learning successfully .
Learning the code :( Latching )
Note: When you choose for latching mode , in order to learn more remote control , you need to learn two different button , the first time learnt is for "ON", the second time learnt for "OFF".
For example : button A = ON , button B = OFF
1. Push the learning key on the receiver triple time , it comes into latching mode .
2. Wait for a moment , the LED indicator on the receiver board will flash then come off.
3. Push the remote button A .
LED flash for 5 times .
4. Push the remote button B .
Led flash for 5 times .
5. After 3 seconds , the LED indicator will be on again , learning successfully.
Learning the code : ( Time delay mode )
1. Push the learning key on the receiver forth time , the time dealy for 5 seconds .
2. Push the learning key on the receiver fifth time , the time delay for 10 seconds .
3. Push the learning key on the receiver sixth time , the time delay for 15 seconds .
The LED indicator will be off .
4. Push the remote button , LED flashes and off .
After 3 seconds , the LED indicator will be on again , learning successfully .
NOTE: The system can store for 25 pcs of remotes , if the remote get more than 25pcs , the initial remote control will be lost .
Package Included :
1 x Wireless Remote Control Switch
